The Royal Python Forum
The Royal Python Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Royal Python Posts
 Royal Python - General Keeping information
 Ceramic heat lamp Setup
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

phlegmatical
Yearling

United Kingdom
403 Posts

Posted - 14/02/2013 :  19:00:54  Show Profile  Reply with Quote
I have recently bought a ceramic heat lamp as advised by other forum users to replace my heat mat, I would just like some advice on where to place it?

I realise it needs to be at the hot end but right up against the side wall or back wall or a few inch away etc.

Also what sort of gap should there be between the actual lamp and lamp guard? mine when installed will be 30mm, is this sufficient?

My wooden vivarium measures 36"x18"x18"

Thanks for your advice

Edited by - phlegmatical on 14/02/2013 19:02:38

blackskull
Fully Grown Royal

United Kingdom
1278 Posts

Posted - 14/02/2013 :  19:12:10  Show Profile  Reply with Quote
My bulbs are about 6 inches from the side and back wall of the viv to the centre ( where i drilled the hole). That gap to the guard should be fine. Think mine might be a bit lower and i have no problems

1.1 normal royal, sully, silver
0.1 pinstripe royal, penny
1.1 pastel royal, lars, clover
0.1 lesser royal, serenity
0.1 black pastel royal, betty
0.1 mojave royal, mavis
0.1 normal het clown
1.0 pastel het clown
1.0 nuclear, ned
1.0 super phantom
1.0 childrens python, myles
0.1 hog island boa
0.1 sonoran x boa, grace
0.0.1 mack snow leopard gecko, munchkin
4.1 cats, stan, dave, marble, binx, daisy
4.1 rabbits, mol, ted, bill, spud, alice
0.1 crazy cat/bunny lady of bridgwater, lucy
Go to Top of Page

phlegmatical
Yearling

United Kingdom
403 Posts

Posted - 14/02/2013 :  19:19:15  Show Profile  Reply with Quote
Thanks for that, wanted to check before i had to put holes in it!
Go to Top of Page

blackskull
Fully Grown Royal

United Kingdom
1278 Posts

Posted - 14/02/2013 :  19:26:35  Show Profile  Reply with Quote
I found it a lot easier if you drill the holes for the cable and screws for the guard before you fix the top in place

1.1 normal royal, sully, silver
0.1 pinstripe royal, penny
1.1 pastel royal, lars, clover
0.1 lesser royal, serenity
0.1 black pastel royal, betty
0.1 mojave royal, mavis
0.1 normal het clown
1.0 pastel het clown
1.0 nuclear, ned
1.0 super phantom
1.0 childrens python, myles
0.1 hog island boa
0.1 sonoran x boa, grace
0.0.1 mack snow leopard gecko, munchkin
4.1 cats, stan, dave, marble, binx, daisy
4.1 rabbits, mol, ted, bill, spud, alice
0.1 crazy cat/bunny lady of bridgwater, lucy
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
The Royal Python Forum © THEROYALPYTHON.co.uk Go To Top Of Page
Snitz Forums 2000